Hydraulic FBK Spin-On Assembly

The FBK series are economical, low pressure filters with spin-on convenience and a wide range of cleanliness ratings and sizes to cover several flow rates. They can be used in both return and suction line configurations.

Features

• Mix and match, stocked heads and filters
• Operating pressure up to 10 bar / 145 psi
• Static pressure testing up to 15 bar / 217.5 psi
• Collapse resistance up to 10 bar / 145 psi
• Flow rate ranges from 60 to 400 lpm / 15.9 to 105.7 gpm
• Service indicators available

Benefits

• Economical
• Spin-on convenience
• Wide range of cleanliness ratings

Applications

• Fluid conditioning systems
• In-plant systems
• Mobile equipment
• Power transmissions
• Process systems
• Return lines
• Side loop systems

Available Media Types

• Donaldson exclusive Synteq™ – synthetic fiber media for greater filtration efficiency and higher dust-holding capacity
• Natural fiber cellulose
• Stainless steel wire mesh

This servicing information is provided as a best practices guide. It is not intended to replace or supersede the service instructions supplied by your engine or vehicle manufacturer.

Spin-on Filter Servicing

1. Check the filter service indicator
   Check to see that the OEM specified service interval has been reached or that the service indicator shows that the filter is due for servicing.
   
   
2. Turn system off and release pressure
   Ensure that the hydraulic system is turned off.
   Check that there is no pressure present.
   
   
3. Unscrew and remove the old filter and gasket
   Properly dispose of the used filter according to local regulations.
    
4. Wipe the filter head with a clean cloth
   
   
5. Inspect the new filter for damage
   Check the new filter you will be installing for any shipping and handling damage. Do not install a damaged filter.
   
   
6. Lubricate threads
   
   
7. Apply a thin film of motor oil to the gasket
   
   
8. Align threads – spin filter until gasket contact
   Fit the housing to the filter head as instructed on the housing.
   
   
9. Follow the icons on the filter to tighten
   Do not over-tighten.
   
   
10. Bleed the system and check for leaks