Duramax® HMK05/25 Hydraulic Spin-On Assemblies

HMK05 (single) and HMK25 (double) Duramax® spin-on filters are perfect for high-flow applications, featuring a heavy-duty steel body and die-cast top plate for added strength. A special head-to-canister o-ring seal prevents leakage. Both HMK05 and HMK25 models use the same replacement filters, with identical pressure ratings, reducing inventory.

Features

• Strong, durable heavy-duty steel body and die-cast top plate construction
• Special head-to-canister o-ring seal prevents leakage
• Nitrile seals are standard, but fluorocarbon seals are available
• Both models have identical pressure ratings and use the same replacement filters for reduced inventory
• Variety of indicator types and by-pass options
• Working pressures to: 24.2 bar / 350 psi
• Rated static burst to: 55.2 bar / 800 psi
• Flow range to:
  • HMK05: 189 lpm / 50 gpm
  • HMK25: 379 lpm / 100 gpm
• Porting size: 
  • HMK05:
    • 1-¼" NPT
    • SAE-20 o-ring
  • HMK25:
    • 1-½" NPT
    • SAE-24 o-ring
    • 1-½" SAE 4-bolt flange code 61
• Standard by-pass ratings:
  • 1.73 bar / 25 psi
  • 3.5 bar / 50 psi
  • No by-pass

Benefits

• Proven Duramax filters deliver dependable performance 
• HMK25 double filter head delivers twice the flow capability and contaminant capacity

Applications

• Case drains
• Cooling circuits
• Fuel transfer
• Hydrostatic charge pumps
• Lube oil systems
• Power transmissions
• Return lines
• Side loop systems
• Fluid conditioning systems

Available Media Types

• Donaldson exclusive Synteq™ – synthetic fiber media for greater filtration efficiency and higher dust-holding capacity
• Water absorbing media
• Wire mesh
• Many different efficiency grades from which to choose

This servicing information is provided as a best practices guide. It is not intended to replace or supersede the service instructions supplied by your engine or vehicle manufacturer.

Spin-On Filter Servicing

1. Check the filter service indicator
   Check to see that the OEM specified service interval has been reached or that the service indicator shows that the filter is due for servicing.
   
   
2. Turn system off and release pressure
   Ensure that the hydraulic system is turned off.
   Check that there is no pressure present.
   
   
3. Unscrew and remove the old filter and gasket
   Properly dispose of the used filter according to local regulations.
    
4. Wipe the filter head with a clean cloth
   
   
5. Inspect the new filter for damage
   Check the new filter you will be installing for any shipping and handling damage. Do not install a damaged filter.
   
   
6. Lubricate threads
   
   
7. Apply a thin film of motor oil to the gasket
   
   
8. Align threads – spin filter until gasket contact
   Fit the housing to the filter head as instructed on the housing.
   
   
9. Follow the icons on the filter to tighten
   Do not over-tighten.
   
   
10. Bleed the system and check for leaks